Autel MaxiIM IM608 Add BMW F012 New Key

Hey guys, we are gonna use Autel MaxiIM IM608 to add a new key for 2014 BMW F012 with 868MHz Frequency via OBD.

Let’s go!

So, enter “IMMO”.

Accept the disclaimer.

Tap “BMW”.

Smart selection.

It will scan the CAS4/CAS4+ immobilizer system, DME engine system, EGS transmission system. Tap “OK”.

Go to “Key learning”.

It will read vehicle information and ECU information.

Enter “OBD learning”.

Nice, it comes with instructions which guide me how to do in step-by-step procedure.

Go to “OBD Read SK” to read the password.

We like to take the risk, so tap “Ok”.

Tap “Yes” to confirm we have a working key, and then put the working key to start coil as close as possible.

Alright, read password quickly.

Pick Key6 (Free key), then tap “Write key”.

Follow the instruction “Please put New key close to start coil, key frequency 868MHz”.

Operate “Key Learning” in two stpes.

The second step of writing data into key is in process.

Write key successfully!

Follow the instruction “Put the key close to start induction coil, press and hold the ignition for 10s. After the learning is completed, the key can be normally used.”.

Take the original key away from the vehicle when testing the new key.

Okay, the new can start the car perfectly.

  • Autel MaxiIM IM608 FAQs: IP Limted/Annual Subscription

    This article answers 4 frequently asked questions and answers on Autel im608 / IM508 key programmer. Does Autel IM608 still have […]

  • How to solve Autel DS708 language problems

    How to solve Autel DS708 language problems   Problem: One of Autel DS708 users came across “The language is not authorized” error during the upgrade procedure.   Solution: The reason is that each Autel DS708 multi-language diagnostic system can only support one language in one device. If you select a different language, you will get the error message. Do not add more than one language when update the device.

  • VAG Group Cars Pre-2011 Autel Service Reset

    Please see the service reset procedure below; Click on the VAG manufacturer, wither Audi, Seat or other and then, Please select Systems Please select Control unit Please selectelectronics 1 Please select Instruments Please select Adaption The diagnostic tool will now ask you for a channel number. Select channel 002. Ask to set a new value and change to 00000. Once done escape from adaption’s and then go back in again. Select channel 053. Ask to set a new value and change to Once done escape from adaption’s and then go back in again. Select channel 054. Ask to set a new value and change to 00000. Once this is done, escape out of adaptions and instruments, turn ignition off and remove key. Leave for 10 seconds – then turn the ignition back on and service message should have cleared.   More information: www.autel.uk   Who Viewed This Article Also Views: OBD2 Scanner Autoboss V30, Autel MaxiDAS DS708 Comparison […]

  • Autel IM508 Autel IM508 Add Smart Remote on 2018 Honda Civic

    Autel IM508 can be used on Honda Civic to add key, do all key lost, reset immobilizer, replace IMMO components (engine/immobilizer/for […]