- VAG Group Cars Pre-2011 Autel Service Reset
Please see the service reset procedure below; Click on the VAG manufacturer, wither Audi, Seat or other and then, Please select Systems Please select Control unit Please selectelectronics 1 Please select Instruments Please select Adaption The diagnostic tool will now ask you for a channel number. Select channel 002. Ask to set a new value and change to 00000. Once done escape from adaption’s and then go back in again. Select channel 053. Ask to set a new value and change to Once done escape from adaption’s and then go back in again. Select channel 054. Ask to set a new value and change to 00000. Once this is done, escape out of adaptions and instruments, turn ignition off and remove key. Leave for 10 seconds – then turn the ignition back on and service message should have cleared. More information: www.autel.uk Who Viewed This Article Also Views: OBD2 Scanner Autoboss V30, Autel MaxiDAS DS708 Comparison […]Autel AutoLink AL519 Reviews
Jack Ason: I want a scanner for most OBDII & CAN-bus protocol car models, I need original not copy, but […]Autel MX808 DPF Forced Regeneration Maintenance
Autel tablets are known for their diagnostic prowess, but the tablet comprehensive hot-key service menu is what gives technicians immediate […]How to connect Autel MaxiDAS DS708 to OBD II/non-OBD II vehicle
How to connect Autel MaxiDAS DS708 to OBD II/non-OBD II vehicle Autel MaxiDAS DS708 Connection Tips How to connect the genuine Autel MaxiDAS DS708 to a vehicle? The method used to connect Autel DS708 to a vehicle’s DLC depends on the vehicle’s configuration— with OBD II vehicle management system or not. This is about original Autel MaxiDAS DS708 connection. Hope it can help you out.